SID         

    COMMANDS    



        Command              Meaning

     As              (Assemble)    Enter assembly language
                                   statements
                                   s is the start address

     Cs{b{,d}}       (Call)        Call to memory location from SID
                                   s is the called address
                                   b is the value of the BC register
                                   pair d is the value of the DE
                                   register pair

     D{W}{s}{,f}     (Display)     Display memory in hex and ASCII
                                   W is a 16-bit word format
                                   s is the start address
                                   f is the finish address

     Epgm-filespec   (Load)        Load program and symbol table
      {,sym-filespec}              for execution

     E*sym-filespec  (Load)        Load a symbol table file

     Fs,f,d          (Fill)        Fill memory with constant value
                                   s is the start address
                                   f is the finish address
                                   d is an eight-bit data item

     G{p}{,a{,b}}     (Go)         Begin Execution
                                   p is a start address
                                   a is a temporary breakpoint

     H                (Hex)        Displays all symbols with
                                   addresses in Hex
     H.a                           Displays hex, decimal, and ASCII
                                   values of a where
                                   a is a symbolic expression

     Ha,b                          Computes hex sum and difference
                                   of a and b where
                                   a and b are symbolic expressions

     Icommand tail   (Input)       Input CCP command line

     L{s}{,f}        (List)        List 8080 mnemonic instructions
                                   s is the start address
                                   f is the finish address

     Ms,h,d          (Move)        Move Memory Block
                                   s is the start address
                                   h is the high address of the block
                                   d is the destination start address

     P{p{,c}}        (Pass)        Pass point set, reset, and display
                                   p is a permanent breakpoint address
                                   c is initial value of pass counter

     Q               (Quit)        Exit SID (for compatibility with
                                   80x86 versions of SID)

     Rfilespec{,d}   (Read)        Read Code/Symbols
                                   d is an offset to each address

     S{W}s           (Set)         Set Memory Values
                                   s is address where value is sent
                                   W is 16 bit word

     T{n{,c}}        (Trace)       Trace Program Execution
                                   n is the number of program steps
                                   c is the utility entry address.

     T{W}{n{,c}}     (Trace)       Trace Without Call
                                   W instructs SID not to trace
                                   subroutines
                                   n is the number of program steps
                                   c is the utility entry address

     U{W}{n{,c}}     (Untrace)     Monitor Execution without Trace
                                   n is the number of program steps
                                   c is the utility entry address
                                   W instructs SID not to trace
                                   subroutines

     V                (Value)      Display the value of the next
                                   available location in memory
                                   (NEXT), the next location after
                                   the largest file read in (MSZE),
                                   the current value of the Program
                                   counter (PC), and the address of
                                   the end of available memory (END)

     Wfilespec,s,f  (Write)        Write the contents of a contiguous
                                   block of memory to filespec.
                                   f is finish address

     X{f}{r}        (Examine)      Examine/alter CPU state.
                                   f is flag bit C,Z,M,E or I.
                                   r is register A,B,D,H,S or P.

  


HELP>